Product Details
|
Dual ports module
Dual power/signal ports,hidden design, support left/rightÂ
modules interchangeable connection. 45°angle design module.
Module 45° angle design, easy to deal with variousÂ
right-angle projects.
|
Metal heat dissipation, good sealing effect
The module is equipped with aluminum alloy heat sink,Â
which has high thermal conductivity and good heatÂ
dissipation effect, ensuring the stable performance ofÂ
the screen.High airtight insulating rubber ring, dustproof,Â
waterproof, moistureproof, excellent airtightÂ
performance.
|
|
|
Front / Rear maintenance
Without environmental constraintsand support theÂ
removal of modules in front and back for maintenance.
|
Hub connection
The whole panel adopts Hub connection betweenÂ
module and receiver for signal and power.
|
|
|
Excellent outdoor protection
Full sealed module, side waterproof design, the protectionÂ
class of the module reaches IP66, sealed power supplyÂ
design. Dust-proof, moisture-proof, anticorrosion, perfectÂ
solution to the three proofings problems of display screen.
|
Â
FAQ
Precautions for LED display environmental environment
1. The temperature range of the working environment -20 ℃ ≤ T ≤ 50 ° C, the operating environment humidity range is 10 % to 90 % RH;
2. Avoid use or storage in high temperature, high humidity, high acid/alkali/salt environment;
3. Far away from flammable materials, gas, dust;
4. Avoid strong collisions during transportation and avoid sharp object collision;
5. When the environmental temperature is too high or the heat dissipation conditions are not good, be careful not to open the screen for a long time;
6. The LED display that exceeds the specified humidity will cause parts to corrode and even cause permanent damage;
7. It is strictly forbidden to conduct electric metal in the screen. The LED display should be placed in a low dust environment. Large dust will affect the display effect, while too much dust will cause damage to the circuit. If you enter the water for various reasons, power off immediately until all components in the screen are dry before using it.
Precautions for LED display switch screen
1. Open the screen: first turn on the control computer so that it can run normally before turning on the LED display large screen;
2. Close screen: First turn off the power supply of the LED screen, turn off the control software, and then turn off the computer correctly;
3. The switching screen time is greater than 5 minutes;
4. Avoid opening the screen under the full white screen, because at this time it is the maximum power state, the impact current of the entire power distribution system is the largest;
http://www.leder-ledvision.com/